Sharkit Index page | Sharkit News | Sharkit home | e-mail me |
Sharkit
BASES
Sculpted by renaud Ask me for prices and availabiity. |
![]() |
![]() |
RECTANGLE CLASSIC BASE "MATERIAL" Click pict to enlarge At the moment only one size: -medium; 7cm x9.5cm Suitable for 1/72 airplane (a bit too small for 1/48) Altuglas & resin, with brass pin. The base walls thickness is about 2mm Another view. |
![]() |
AVRO BASE Three sizes: -"Little"; its more an insigna: wingspan 8cm. -large 15,5cm thick 9mm Carved by renaud for the sharkit 1/72. Avrocar. From the Avro logo. The base shown left is from a resin load with aluminium powder, and polished with graphit for a steel effect. |
![]() |
AVRO BASE
WITH LEAF BASE Two sizes: -med: 11cm thick 9mm. -large: 15,5cm thick 9mm. ![]() Click pict up |
![]() |
LOCKHEED STAR
ROCKBASE Carved by renaud for the sharkit L-133. One size: -med -large The leg is a metal wire to be inserted in a hole above the "H" of Lockheed. |
![]() |
TRIDENT BASE One size: -large: 9,5cm x 16cm, thick max 14mm Design by renaud for a 1/48 Trident desk airplane. The leg is a metal wire to be inserted in a hole in the center of the base (this hole is not drilled on the pict left) |
![]() |
EAGLE
SHARKIT BASE One size: -med: 9cm x 9cm, thick max 11mm Design by renaud for the sharkit Rocketteer. The leg is a metal wire to be inserted in the hole in the back of the eagle. The Sharkit logo can be easely cut and removed is wished. ![]() Click pict up |
![]() |
EAGLE
X4 BASE One size: -med: Wingspan 10cm, thick 16mm Carved by renaud for the sharkit RuhrstahlKramer X4. From the Luftwaffe eagle. The leg is a metal wire to be inserted in between the two eagles wings. |
![]() |
TELLURAN
BASE (picture left) two sizes: -med1 Diameter 7.5cm, thick max 16mm. -med2 Diameter 9cm, thick max 23mm. Design by renaud, multipupose. The leg is a metal wire to be inserted in the center. |
![]() |
TELLURAN LARGE FLAT
BASE (picture left) Multipupose. The thickness is about 6/8mm everywhere. Diameter 11.4cm, thick max 11mm. Design by renaud for the sharkit MYASSITCHEV M-40 BURAN The leg is a metal wire to be inserted in the center. |
![]() |
WATER-DROP BASE One size: -med: 8.7cm x 5.7cm, body thick max 15mm Design from the Golden Age... Elegance needs no words... The leg is a metal wire to be inserted at the top. |
![]() |
NASA PLATE And NASA X-15 base Plate size: 12,5cm x 4cm, thick 3mm. Design by renaud for the Sharkit X-15 delta ![]() Click pict up |
![]() |
X BASE for large X-plane... -med size: 16cm x 15cm, thick max 13mm hight 12cm The leg "snap" the three parts together ![]() Design by renaud for the Sharkit Bell X-16 |
![]() |
BOMARC type BASE This is the simplified base include in the sharkit Bomark kit. The brown board is not provide. Four resin parts, some sticking required The axle is a metal bolt, include. -size: 14cm x 3,8cm, arm 16cm long ![]() |